Board and Batten Spacing Calculator

Compare evenly spaced decorative battens using your wall measurements. Preview a layout and see positions measured from the left edge.

Advertisement

Includes one batten flush with each side edge. All open gaps between battens are equal. No side gaps.

Units

Enter the actual face width of the batten, not a nominal size if those differ.

A whole number from 2 through 60, including the two edge battens.

This is the height of the rectangular decorative area in the drawing, not a validated wall or cut height. It changes the preview only, not the spacing.

How the spacing is calculated

The layout includes one batten flush with each side edge. The remaining battens are placed so that every open gap between battens is equal, with no extra gap at the sides. If W is the wall width, B is the actual batten face width and N is the batten count, the number of open gaps is N − 1. The clear gap is (W − N × B) ÷ (N − 1). The center-to-center distance, or pitch, is B plus that clear gap. Positions are measured from the wall’s left edge and are calculated from the unrounded pitch. Preview height does not change these distances. A layout with no positive open gap is not calculated.

Calculations run in your browser. Nothing you type is sent to our servers.

Frequently asked questions

What is the difference between the clear gap and the center-to-center distance?

The clear gap is the open edge-to-edge space between neighboring battens. The center-to-center distance, or pitch, is the batten face width plus that clear gap. This calculator shows both, along with left-edge and center positions measured from the wall’s left edge.

Does this calculator account for doors, windows or outlets?

No. It is a decorative interior spacing estimate only. Openings, outlets, switches, rails, uneven walls, substrate, fasteners and installation requirements are not modeled.

Are the displayed measurements exact enough to cut boards?

No. Displayed measurements are rounded estimates, not cutting precision. Use your actual materials, verify measurements, and check the layout on the wall before installation.

Which units can I use?

You can enter measurements in decimal inches or in centimeters. In inches, 10 ft equals 120 in. Enter decimal inches rather than feet-and-inches or fractions.

Advertisement

Disclaimer

This independent tool is a decorative spacing estimate only. It is not installation, structural, electrical or building-code advice, and it does not model openings or materials takeoffs. Calculations run in your browser; nothing you type is sent to our servers.